Pinnacle - Hard-Set, Transitional Pressure Sensitive Adhesive

ONLY AVAILABLE FOR SALE WITH PURCHASE OF THE FLOORING

APPROVED FLOORING TYPES

RESILIENT: Linoleum, Modular (LVP, LVT, rigid core [dryback], SVT, VCT, VET, woven), Rubber (crumb, sheet, tile), Sheet (fiberglass, heterogeneous, homogeneous, woven), Stair Treads (rubber, vinyl)

CARPET: Broadloom (6-ft vinylbacked)

WOOD: Cork (cork-backed hard surface, underlayment)

APPROVED SUBSTRATES & SURFACES

APA underlayment grade plywood and OSB • Association grade particleboard • Cementitious and anhydrite screeds • Cement backer board • Concrete and radiant heated subfloors that do not exceed 85°F (30°C) • Existing well-bonded non-cushion-backed vinyl, tile and sheet flooring • Fully secured cork underlayments • Gypsum and lightweight concrete (primed with TAYLOR 2025, Zephyr® or Enhance®) • Terrazzo (properly prepared with all waxes and surface finishes removed) SUBSTRATE TESTING RH - 99% [ASTM F2170] pH - 5-12 [ASTM F710] MVER - 12 lbs [ASTM F1869]

APPROXIMATE COVERAGE ( Coverage is approximate and may vary depending on porosity of substrate and the angle at which the trowel is held.)

- 1/16” x 1/32” x 1/32” U Notch - 220 sq ft/gal

- 1/16” x 1/16” x 1/16” Sq Notch - 150 sq ft/gal

- 3/8” Short Nap Paint Roller - Up to 350 sq ft/gal

*It is the sole responsibility of the contractor/installer to determine the proper porosity of the subfloor, apply the correct amount of adhesive for the job conditions and ensure that all instructions, procedures and practices are strictly adhered to.